Pinpoint Test F : 2535 (With Push Button Start)
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- F1 RETRIEVE DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, perform PCM self-test.
Is DTC P2535 recorded?
Yes GO to F2 No For all PCM Diagnostic Trouble Codes (DTCs), refer to PCM DTC Chart . - F2 CHECK THE CRANK DETECT CIRCUIT FOR A SHORT TO VOLTAGE WITH PCM (POWERTRAIN CONTROL MODULE) DISCONNECTED
- Ignition OFF.
- Disconnect PCM C1551B.
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C1551B-47 Ground
Is any voltage present?
Yes GO to F3 No GO to F5 - F3 CHECK THE CRANK DETECT CIRCUIT FOR A SHORT TO VOLTAGE WITH IGNITION SWITCH - PUSH BUTTON START DISCONNECTED
- Ignition OFF.
- Disconnect Ignition switch - Push Button Start C2195.
- Measure:
Positive Lead Measurement / Action Negative Lead C1551B-47 Ground
Is any voltage present?
Yes GO to F4 No INSTALL a new ignition switch - push button start. REFER to: Ignition Switch - Vehicles With: Keyless Vehicle System . - F4 CHECK THE CRANK DETECT CIRCUIT FOR A SHORT TO VOLTAGE WITH BCM (BODY CONTROL MODULE) DISCONNECTED
- Ignition OFF.
- Disconnect BCM C2280H.
- Measure:
Positive Lead Measurement / Action Negative Lead C1551B-47 Ground
Is any voltage present?
Yes REPAIR the circuit. No GO to F6 - F5 CHECK FOR CORRECT PCM (POWERTRAIN CONTROL MODULE) OPERATION
- Disconnect and inspect all PCM connectors.
- Repair:
- corrosion (install new connectors or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect all connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, refer to PCM Guided Routine Testing . . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. - F6 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
- Disconnect and inspect all BCM connectors.
- Repair:
- corrosion (install new connectors or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect all connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, refer to BCM Guided Routine Testing . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.