Inspection and Verification
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
- Verify the customer concern.
- Check the battery for loose, damaged or corroded connections.
- Check the starter for loose, damaged or corroded connections.
- Check the battery condition and state of charge. REFER to: Battery .
- Remove the accessory drive belt. REFER to: Accessory Drive Belt . Verify the crankshaft and each of the components driven by the accessory drive belt rotate and are not seized or damaged.
- If any aftermarket accessories have been added to the vehicle, make sure they are properly wired.
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding.