Coolant Pump: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Remove the accessory drive belt. Refer to: Accessory Drive Belt .
- Remove the engine mount. Refer to: Engine Mount .
- Remove the thermostat. Refer to: Thermostat .
-
NOTE: If necessary, use a suitable tool to hold the pulley.
Remove the bolts and the coolant pump pulley.
- Release the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer
-
NOTE: Use caution to prevent damage to the coolant inlet pipe grommet.
Remove the bolts and the coolant pump.
- Remove and discard the coolant pump gasket and seal.