Coolant Outlet Connector: Installation
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Position the hose clamp and install the coolant hose and coolant inlet pipe assembly. Use the General Equipment: Hose Clamp Remover/Installer
-
- Place the coolant outlet connector and inlet pipe assembly into the intake valley. Verify the locator dowel is fully seated into the engine block.
- Verify the coolant inlet tube tab is at the 6 O'clock position and flush with the rear of the front cover housing opening.
- Install and tighten the fasteners. Connect the coolant hoses and position the hose clamps. Use the General Equipment: Hose Clamp Remover/Installer
Torque: 89 lb.in (10 Nm)
-
- Connect the coolant hose and tighten the hose clamp.
Torque: 44 lb.in (5 Nm)
- Depress the tabs and connect the coolant tube.
- Connect the knock sensor harness retainer to the stud bolt.
- Connect the coolant hose and tighten the hose clamp.
- Install the coolant pump. Refer to: Coolant Pump .
- Install the fuel rail. Refer to: Fuel Rail .