Coolant Pump: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the O-ring seal with clean engine coolant. Install the coolant pump and the bolts.
Material: Motorcraft® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)

Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Position the coolant pump pulley and install the bolts finger tight.

Courtesy of FORD MOTOR COMPANY
Remove the waterproof plastic from the A/C belt.
Rotate the accessory drive belt tensioner and install the accessory drive belt.

Courtesy of FORD MOTOR COMPANY
Tighten the coolant pump pulley bolts.
Torque: 177 lb.in (20 Nm)

Courtesy of FORD MOTOR COMPANY
1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.
  
  Lubricate each grommet with silicone grease.
  
  Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)
2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
Courtesy of FORD MOTOR COMPANY
Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .