Valve Cover LH: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
NOTE:
Installation of new spark plug seals or VCT seals is only required if seals are damaged.
- Remove the air cleaner. Refer to: Air Cleaner .
- Remove the engine appearance cover.
- Remove the crankcase vent tube. Refer to: Quick Release Coupling
.
- Remove the ignition coil-on-plugs. Refer to: Ignition Coil-On-Plug .
- Remove the oil level indicator.
- Disconnect the wire harness retainers and position aside the wire harness.
- Disconnect the electrical connectors and the wire harness retainers.
-
NOTE: While removing the valve cover do not apply excessive force to the VCT oil control solenoid or damage may occur.NOTE: If the VCT oil control solenoid sticks to the VCT seal, carefully wiggle the valve cover until the bond breaks free or damage to the VCT seal and VCT oil control solenoid may occur.
Loosen the bolts and remove the valve cover.
- Remove and discard the gasket.
-
NOTE: Inspect the VCT solenoid seals. Remove any damaged seals.
Using the special tools, remove and discard the seal(s). Use Special Service Tool: 205-142 (T80T-4000-J) Installer, Differential Bearing Cone, 205-153 (T80T-4000-W) Handle.
-
NOTE: Inspect the spark plug tube seals. Remove any damaged seals.
Using the special tools, remove and discard the seal(s). Use Special Service Tool: 303-1247 VCT Spark Plug Tube Seal Remover and Installer, 205-153 (T80T-4000-W) Handle.
- Clean the valve cover, cylinder head and engine front cover sealing surfaces with metal surface prep.
Material: Motorcraft® Metal Surface Prep Wipes / ZC-31-B