LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (ENGINE - 2.7L ECOBOOST (238kW/324PS)) >> Removal And Installation >> Valve Cover RH >> Installation

Valve Cover RH: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Installation of new seals is only required if damaged seals were removed.

    Using the special tools, install new spark plug tube seals. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1247 VCT Spark Plug Tube Seal Remover and Installer.

    GFD278364Courtesy of FORD MOTOR COMPANY
  2. Install a new gasket.
    GFD278365Courtesy of FORD MOTOR COMPANY
  3. Apply clean engine oil to the surface.

    Material: Engine Oil - SAE 5W-30 - Synthetic Blend Motor Oil / XO-5W30-Q1SP (WSS-M2C946-B1)

    GFD278366Courtesy of FORD MOTOR COMPANY
  4. NOTE: If the valve cover is not installed and the fasteners tightened within 10 minutes, the sealant must be removed and the sealing area cleaned.

    Apply an 8 mm (0.31 in) bead of Motorcraft® High Performance Engine RTV Silicone to the engine front cover-to-cylinder head joints.

    Material: Motorcraft® High Performance Engine RTV Silicone / TA-357 (WSE-M4G323-A6)

    GFD278367Courtesy of FORD MOTOR COMPANY
  5. Install the valve cover and tighten the bolts.

    Torque: 89 lb.in (10 Nm)

    Fig 1: RH Valve Cover Tightening Sequence
    GFD278368Courtesy of FORD MOTOR COMPANY
  6. Install the RH coil-on-plugs. Refer to: Ignition Coil-On-Plug .
    • Connect the TC vacuum supply tube. Use the General Equipment: Hose Clamp Remover/Installer

    • Attach the vacuum tube retainers.

    GFD278269Courtesy of FORD MOTOR COMPANY
    • Attach the vacuum tube and coolant tube retainers.

    • Connect the engine wiring harness electrical connector and retainers.

    GFD278268Courtesy of FORD MOTOR COMPANY
    • Connect the engine harness electrical connector and attach the retainer.

    • Connect the PCM electrical connector.

    GFD278173Courtesy of FORD MOTOR COMPANY
  10. Attach the wiring harness retainer.
    GFD278550Courtesy of FORD MOTOR COMPANY
    1. Position the PCV tube and connect the quick release couplings. Refer to: Quick Release Coupling .
    2. Connect the throttle body electrical connector.
    GFD278265Courtesy of FORD MOTOR COMPANY
  12. Install the following items:

    1. RH charge air cooler intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
    2. Refer to: Air Cleaner Outlet Pipe RH .
    3. Refer to: Cowl Panel .

    1. Install the engine appearance cover and the nut.

      Torque: 42 lb.in (4.8 Nm)

    2. Install the bolt.

      Torque: 93 lb.in (10.5 Nm)

GFD278211Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals