LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Steering Column) >> Removal And Installation >> Steering Column Tilt Motor >> Installation

Steering Column Tilt Motor: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. If equipped with memory steering column, use the steering column control switch and set the tilt motor soft stops as follows.

    1. Move the column upward until it reaches the end of travel.
    2. Move the column in the same direction until it reaches the end of travel again.
    3. Move the column downward until it reaches the end of travel.
    4. Move the column in the same direction until it reaches the end of travel again.

    GFD277394Courtesy of FORD MOTOR COMPANY
  3. If equipped with memory steering column, use the steering column control switch and set the telescopic motor soft stops as follows.

    1. Move the column rearward until it reaches the end of travel.
    2. Move the column in the same direction until it reaches the end of travel again.
    3. Move the column forward until it reaches the end of travel.
    4. Move the column in the same direction until it reaches the end of travel again.

GFD277395Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals