LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Anti-Lock Brake System (Abs) And Stability Control) >> Removal And Installation >> Hydraulic Control Unit (HCU) >> Installation

Hydraulic Control Unit (HCU): Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. Bleed the brake system. Refer to: Brake System Pressure Bleeding .
  3. If a new HCU is being installed, carryout the IVD Initialization Sequence and Valve Calibration using the scan tool and following the scan tool on-screen instructions.
scientia non olet · About LEMON Manuals