Brake Master Cylinder: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE:
Removal steps in this procedure may contain installation details.
-
NOTE: Before removing the master cylinder, relieve the vacuum in the brake booster or the master cylinder O-ring seal may be drawn into the brake booster, causing brake booster failure and increased brake pedal effort.
Fully apply and release the brake pedal 5 times.
- Remove the battery. Refer to: Battery .
- Disconnect the brake fluid level sensor electrical connector and detach the wiring retainer.
- Disconnect the brake tube fittings.
Torque: 20 lb.ft (27.5 Nm)
- Remove the nuts and the brake master cylinder. Discard the nuts.
Torque: 20 lb.ft (27.6 Nm)
- Make sure that the master cylinder-to-booster seal is removed with the master cylinder.