Switch and Control

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

When the roof opening panel glass is in the fully closed position, pushing the roof opening panel control open switch will activate the one-touch open feature, first opening the roof opening panel shield if it is closed, then opening the roof opening panel glass. With the roof opening panel glass in any open position, pushing the roof opening panel control close switch will activate the one-touch close feature which will close the roof opening panel glass to approximately 8 in. (200mm) from the closed position and then the switch must be held to full close. When in one-touch open or close mode, activating any roof opening panel control switch will cancel the one-touch operation and stop the glass movement. Near the end of forward travel while closing, the front of the roof opening panel glass moves downward into the cams. This allows a weather-tight seal when the roof opening panel glass is closed. The roof opening panel control switch has a separate roof opening panel shield open and close switches to operate the shield independent from the glass. The shield will not close if the glass is in the open position.

When the roof opening panel glass is in the closed position, pushing the roof opening panel control switch tilt switch will open the roof opening panel sliding panel to the vent position. When the roof opening panel glass is in the vent position, pushing the roof opening panel close switch will close the roof opening panel glass.