LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Instrument Panel And Console) >> Removal And Installation >> Instrument Panel >> Installation

Instrument Panel: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Lubricate and install new O-ring seals.

    Material: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)

  3. Fill and bleed the cooling system. Refer to filling and bleeding without a vacuum cooling system filler. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding - 3.5L . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding - 2.7L . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding - 2.0L .
  4. NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the EPB module. Perform the following step to restore the EPB system and clear the EPB module DTC.

    Apply and release the parking brake twice within 5 seconds, pausing with the switch in the NEUTRAL position for approximately one-half second between each apply and release.

scientia non olet · About LEMON Manuals