Rear Door Window Glass: Removal
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LH side shown, RH side similar.
- Remove the rear door trim panel. Refer to: Rear Door Trim Panel .
- Install the rear window control switch and lower the rear window glass to full down position.
- Remove the rear door watershield.
- Remove the rear door speaker.
- Disconnect the electrical connector and position aside the wiring harness.
- Remove the retainers and remove the rear door speaker.
Torque
: 22 lb.in (2.5 Nm)
- Position the rear door window glass to the one-half position.
- Lower the window glass to the full down position.
- Release the rear door window clip.
- Move the rear door window glass out of the rear door window clip.
- Lower the window glass to the full down position.
- Remove the aft rear door upper moulding. Refer to: Rear Door Upper Moulding .
- Remove the retainers and the inner upper door trim.
- Remove the rear door window glass.