Driver Power Seat - With Memory
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
The power driver seat is controlled by the DSM. The DSM is located on the driver seat track. PMI is required when a new DSM is installed. The DSM hard stop/soft stops must be set/reset any time a new DSM, driver seat track, horizontal motor or driver seat backrest is installed.
The memory system allows automatic positioning of the driver seat to 1 of 3 programmable positions. For information on programming memory positions or recalling a stored memory position, refer to the Owner's Literature.
The driver memory seat is equipped with the following motors:
- Front height motor (serviced with seat track assembly)
- Rear height motor (serviced with seat track assembly)
- Horizontal motor (serviced separately from the seat track assembly)
- Recliner motor (serviced with seat backrest assembly)
- Lumbar motor (serviced with power lumbar assembly)