Pinpoint Test C : The Power Liftgate Is Inoperative From One Of The Liftgate Control Switches: Notes
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Power Liftgate for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Body Closures - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B12E8:11 | Liftgate/Tailgate Control/Release Switch: Circuit Short To Ground | Sets when the BCM detects a short to ground from the exterior liftgate release switch input circuit. |
Possible Causes
- Wiring, terminals or connectors
- Front interior power liftgate switch
- Rear interior power liftgate switch
- Exterior liftgate release switch
- BCM
- RGTM
Visual Inspection and Diagnostic Pre-checks
- Check the power liftgate setting in the message center and make sure the switch is enabled. If disabled, change the setting to enable and re-check the power liftgate operation.