Pinpoint Test N : U0212:00

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

N1 VERIFY THE CUSTOMER CONCERN

Ignition ON.

Verify there is an observable symptom present.

Is an observable symptom present?

Yes

GO to N2

No	The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

N2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a diagnostic scan tool, perform the network test.
Does the SCCM pass the network test?

Yes GO to N3

No REFER to: Communications Network .

N3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE CCM (CRUISE CONTROL MODULE) AND SCCM (STEERING COLUMN CONTROL MODULE) SELF-TEST

Using a diagnostic scan tool, perform the CCM and SCCM self-tests.

Is DTC U3003:16 or DTC U3003:17 recorded?

Yes	For CCM, DTC U3003:16, GO to Pinpoint Test Q For CCMDTC U3003:17, GO to Pinpoint Test R For the SCCM, REFER to: Steering Wheel and Column Electrical Components .

GO to N4

N4 RECHECK THE CCM (CRUISE CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the Programmable Module Installation (PIM) or the Programmable Module Installation (PIM) may not have been carried out.

Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Repeat the CCM self-test.

Is DTC U0212:00 still present?

Yes

GO to N5

No	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

N5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0212:00 SET IN OTHER MODULES
- Clear all Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U0212:00 set in other modules?

Yes INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) .

No INSTALL a new CCM. REFER to: Cruise Control Module (CCM) .