Pinpoint Test C : The STOPLAMPS Are On Continuously: Notes
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Exterior Lighting - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1115:15 | High Mounted Stop Lamp Control: Circuit Short To Battery Or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the high mounted stoplamp voltage supply circuit. |
| B1444:15 | Left Rear Stop/Position Lamp Output: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the left rear stoplamp voltage supply circuit. |
| B1448:15 | Right Rear Stop/Position Lamp Output: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the right rear stoplamp voltage supply circuit. |
| C0040:12 | Brake Pedal Switch "A": Circuit Short To Battery | An on-demand DTC that sets when the BCM detects a short to voltage from the stoplamp switch input circuit during the on-demand self-test. |
Possible Sources
- Wiring, terminals or connectors
- Stoplamp switch
- PCM
- BCM