Pinpoint Test F : B142E:78 Or B1433:54
- F1 INSPECT THE CCM (CRUISE CONTROL MODULE) BRACKET
- With the vehicle in NEUTRAL, position it on a hoist. REFER to: Jacking and Lifting - Overview .
- Remove the front lower air deflector.
- Inspect for damage to the CCM bracket.
Is the CCM bracket damaged?
Yes REPAIR or INSTALL a new CCM bracket as necessary. REFER to: Cruise Control Module (CCM) . No GO to F2 - F2 PERFORM THE VERTICAL AND HORIZONTAL ALIGNMENTNOTE: Remove the front bumper cover to carry-out the vertical alignment procedure.
- Perform the alignment procedures for the CCM. REFER to: Cruise Control Radar Alignment .
Does the CCM align correctly?
Yes The system is operating correctly at this time. The concern was caused by a misaligned sensor. No GO to F3 - F3 CHECK FOR CORRECT CCM (CRUISE CONTROL MODULE) OPERATION
- Ignition OFF.
- Disconnect and inspect the CCM connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the CCM connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.