Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.

To install, reverse the removal procedure.
NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool to the module using the Programmable Modules Installation routine.

Use the General Equipment: Ford Diagnostic Equipment
Carry out the KOEO ELCM Self-Test after programming the PCM to relearn fuel system data. Refer to the instruction manual provided by the scan tool manufacturer.
NOTE: The step is only necessary when installing a new component.
- Carry out the Parameter Reset procedure.
- Vehicles without keyless entry and push button start. Refer to: Passive Anti-Theft System (PATS) (Hybrid/Energi) .
- Vehicles with keyless entry and push button start. Refer to: Anti-Theft Security Access and Key Programming - Scan Tool .