Block Heater: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.
Refer to: Engine Cooling System Health and Safety Precautions .
- Refer to: Cooling System Draining, Filling and Bleeding .
- Refer to: Catalytic Converter - Hybrid Electric Vehicle (HEV) .
-
NOTE: Note the position of the component before removal.NOTE: Make sure that the component is installed to the position noted before removal.
Material: Motorcraft ® Threadlock 262 / TA-26 (WSK-M2G351-A6)
Torque: 41 lb.ft (55 Nm)