LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 102 (ENGINE CONTROLS - FUEL CHARGING AND CONTROLS - 2.0L DURATEC - HYBRID/ENERGI (103kW/140PS) (UA)) >> Removal And Installation >> Fuel Rail >> Installation

Fuel Rail: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Use O-ring seals that are made of special fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak. Do not reuse the O-ring seals.
    NOTE: Make sure that 8 new fuel injector O-ring seals and 4 new fuel injector retainer clips are installed.

    Material: Motorcraft ® SAE 0W-20 Synthetic Blend Motor Oil / XO-0W20-QSP (WSS-M2C947-A)

    GFD198035Courtesy of FORD MOTOR COMPANY
  2. To install, reverse the removal procedure.