Roof Opening Panel Alignment

Adjustment

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .
On both sides. Detach the top portion of the roof opening panel blind and fold it down to get access to the roof opening panel glass retainers.

Courtesy of FORD MOTOR COMPANY
NOTE: Roof opening panel blind removed for clarity.

On both sides. Loosen the retainers for adjustment.

Courtesy of FORD MOTOR COMPANY
Measure and if necessary, adjust the front sliding glass panel to roof and roof height at the front of the glass as displayed below.
- Center line -1.8 +/- 2.1mm
- Outboard line -1.8 +/- 1.8mm
Courtesy of FORD MOTOR COMPANY
Measure and if necessary, adjust the front sliding glass panel to roof and roof height at the rear of the glass as displayed below.
- Outboard line 0.30 +/- 1.8mm
- Center line 0.30 +/- 2.1mm
Courtesy of FORD MOTOR COMPANY
On Both sides. Tighten the retainers.
Torque: 53 lb.in (6 Nm)

Courtesy of FORD MOTOR COMPANY
On Both sides. Attach the top portion of the roof opening panel blind to the drip link.

Courtesy of FORD MOTOR COMPANY
Initialize the power roof opening panel. Refer to: Power Roof Opening Panel Initialization .