Disassembly And Assembly Of Subassemblies: Piston: Assembly

WARNING: This page is about a different variant/trim than selected.

NOTE: Align the piston-to-connecting rod orientation marks made during disassembly.

Courtesy of FORD MOTOR COMPANY
Gradually heat the pin bore side of the connecting rod to approximately 250 °C-300 °C (482 °F-572 °F) and immediately install the piston pin.

Courtesy of FORD MOTOR COMPANY
Material: Motorcraft ® SAE 0W-20 Synthetic Blend Motor Oil / XO-0W20-QSP (WSS-M2C947-A)

Courtesy of FORD MOTOR COMPANY
NOTE: Align the piston rings on the piston.
1. Upper oil control segment ring gap location.
2. Oil control spacer gap location.
3. Lower oil control segment ring gap location.

Courtesy of FORD MOTOR COMPANY