LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 125 (ENGINE EMISSION CONTROL SYSTEM - 2.0L DURATEC - HYBRID/ENERGI (103kW/140PS) (UA)) >> Removal And Installation >> Exhaust Gas Recirculation (EGR) Valve >> Installation

Exhaust Gas Recirculation (EGR) Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Make sure that the mating faces are clean and free of foreign material.
    NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the exhaust gas recirculation (EGR) valve gasket.

    To install, reverse the removal procedure.

    Material: Motorcraft® Metal Surface Prep / ZC-31-A

scientia non olet · About LEMON Manuals