LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion S >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes -- Fusion (Except Hybrid) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BM : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative >> Pinpoint Test BM : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

Pinpoint Test BM : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

  1. BM1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BM2
    No   

  2. BM2 CHECK THE TURN SIGNAL INDICATOR OPERATION

    • Verify the RH and LH turn signal indicators operate correctly.

    Do the turn signal indicators operate correctly? 

    Yes  GO to  BM3
    No  GO to Pinpoint Test T 

  3. BM3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  Refer to: Body Control Module (BCM) .
    No   
scientia non olet · About LEMON Manuals