Pinpoint Test K : U0155:87: Notes
Refer to Vehicle Dynamic Suspension for schematic and connector information.
Normal Operation and Fault Conditions
With the ignition ON, the IPC sends messages to the GWM over the HS-CAN3. The GWM sends these messages to the VDM over the HS-CAN2. If the VDM does not receive these messages within a certain time frame, the module sets Diagnostic Trouble Codes (DTCs). For information on the messages sent to the VDM by the IPC, refer to Network Message Chart . Refer to: Vehicle Dynamic Suspension - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | This DTC sets in continuous memory if the message center information message is missing. |
Possible Sources
- Wiring, terminals or connectors
- Network communication concern
- Vehicle battery
- Charging system concern
- GWM
- IPC