LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion Platinum, FWD >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension System - Fusion (Except Hybrid) >> Diagnosis And Testing >> Vehicle Dynamic Suspension >> Pinpoint Tests >> Pinpoint Test B : U3003:17 >> Notes

Pinpoint Test B : U3003:17: Notes

Refer to Vehicle Dynamic Suspension for schematic and connector information.

Normal Operation and Fault Conditions 

The VDM requires an operating voltage that is between 9 and 16 volts. The VDM receives this voltage from the BCM. The VDM has a single ground circuit. Excessive resistance or an open in one or more of these circuits, a discharged battery or a inoperative charging system results in the VDM setting a DTC.

An overcharging condition in the charging system results in the VDM setting a DTC. This DTC may also set in the VDM due to battery charging or vehicle jump starting events.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
U3003:17 Battery Voltage: Circuit Voltage Above Threshold This DTC sets in continuous memory and on-demand if the voltage supplied to the VDM is above 16 volts for more than 3 seconds.

Possible Sources 

scientia non olet · About LEMON Manuals