Pinpoint Test H : TCC (Torque Converter Clutch) Solenoid: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Transmission Controls - 6F50/6F55 for schematic and connector information.
Normal Operation and Fault Conditions
The PCM controls torque converter lock-up by varying the amount of current applied to the TCC solenoid. When no current is applied to the TCC solenoid, the TCC is fully released. When maximum current is applied, the TCC is fully applied.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0740 | Torque Converter Clutch Solenoid Circuit/Open | Open circuit in the TCC solenoid or wiring harness. |
| P0742 | Torque Converter Clutch Solenoid Circuit Stuck On | Short to ground in the TCC solenoid or wiring harness. |
| P0743 | Torque Converter Clutch Solenoid Circuit Electrical | Open or short to ground in the TCC solenoid or wiring harness. |
| P0744 | Torque Converter Clutch Solenoid Circuit Intermittent | Short to power in the TCC solenoid or wiring harness. |
| P2760 | Torque Converter Clutch Pressure Control Solenoid Intermittent | Intermittent circuit in the TCC solenoid or wiring harness. Open, short to ground or short to power. |
Possible Sources
- Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
- TCC solenoid
- Transmission internal wiring harness frame
- PCM