LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion Platinum, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Automatic Transmission - 6F50/6F55 - Fusion (Except Hybrid)) >> Diagnosis And Testing >> Automatic Transmission >> Pinpoint Tests >> Pinpoint Test E : Shift Solenoid E (SSE) >> Notes

Pinpoint Test E : Shift Solenoid E (SSE): Notes

WARNING: This page is about a different variant/trim than selected.

Refer to Transmission Controls - 6F50/6F55 for schematic and connector information.

Normal Operation 

SSE controls the multiplexing of the SSD low/reverse and overdrive clutch. If SSE fails off (no pressure) then 1st gear is failed to 4th gear. If clutch select valve 2 sticks in the default position then 1st gear with engine braking is failed to 4th gear and reverse is failed to neutral. SSE is an On/Off solenoid.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
P0770 SSE Open, short to power or short to ground in the solenoid or wire harness.
P0773 SSE Electrical Open or short to ground in the solenoid or wire harness.
P0774 SSE Intermittent Intermittent circuit in the solenoid or wire harness open, shorted to ground or shorted to power.

Possible Sources 

scientia non olet · About LEMON Manuals