LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fusion Platinum, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Electronic Engine Controls System - 1.5L ECOBOOST (118KW/160PS) - I4) >> Removal And Installation >> Intake Air Temperature 2 (IAT2) Sensor >> Removal

Intake Air Temperature 2 (IAT2) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the IAT sensor electrical connector and remove the IAT sensor.
    GFD193869Courtesy of FORD MOTOR COMPANY

    Torque: 124 lb.in (14 Nm)

scientia non olet · About LEMON Manuals