Valve Springs: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Use a small screwdriver and multi-purpose grease to install the valve collets.

NOTE: Check the seating of the valve collets.

Using the special tools, install the valve springs, valve spring retainers and the valve collets.

Use Special Service Tools: 303-300 (T87C-6565-A) Set, Valve Spring Compressor, 303-350 (T89P-6565-A) Compressor, Valve Spring, 303-472 (T94P-6565-AH) Adapter, Valve Spring Compressor.

Material: Motorcraft ® Multi-Purpose Grease Spray / XL-5-A (ESB-M1C93-B)

Courtesy of FORD MOTOR COMPANY
Disconnect the compressed air supply.
Repeat the appropriate removal and installation steps for all of the other cylinders.
Install the spark plugs. Refer to: Spark Plugs .
Install the valve tappets. Refer to: Valve Tappets .