Heated Steering Wheel Module (HSWM): Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This step is only necessary when installing a new component.

NOTE: The PMI process must begin with the current HSWM installed. If the current HSWM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

Using a diagnostic scan tool, begin the PMI process for the HSWM following the on-screen instructions.
Remove the driver knee airbag. Refer to: Driver Knee Airbag .
Position the steering column in the full forward/down position.

Courtesy of FORD MOTOR COMPANY
- Disconnect the electrical connector.
- Remove the bolts and the HSWM.
  Torque: 22 lb.in (2.5 Nm)
Courtesy of FORD MOTOR COMPANY