Pinpoint Test F : B1310:12

F1 CHECK THE BJB (BATTERY JUNCTION BOX) RUN/START RELAY
- Ignition OFF.
- Disconnect BJB Run/Start Relay.
- Carry out the appropriate relay component test. Refer to Component Testing for schematic and connector information.
Is the relay OK?

Yes GO to F2

No INSTALL a new BJB run/start relay.

F2 CHECK THE RUN/START RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE

Disconnect BCM C2280C .

Measure:

Positive Lead	Measurement / Action	Negative Lead
C2280C-25	Courtesy of FORD MOTOR COMPANY	Ground

Is any voltage present?

Yes	REPAIR the circuit.

No

GO to F3

F3 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION

Disconnect and inspect all BCM connectors.
Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
Reconnect the BCM connectors and all other previously disconnected connectors. Make sure they seat and latch correctly.
Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Refer to BCM Hardware Testing -- Fusion (Except Hybrid)

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.