Wheel Bearing and Wheel Hub - RS: Installation
- Install the wheel bearing and wheel hub and install the new wheel bearing and wheel hub bolts in the sequence shown.
Torque
: 81 lb.ft (110 Nm)
-
NOTE: Make sure a new bolt is installed.NOTE: Only tighten the nut finger tight at this stage.
- Install the brake disc. Refer to: Brake Disc - RS .
- Install the rear wheel speed sensor. Refer to: Rear Wheel Speed Sensor - RS .
-
NOTE: Apply the brake to keep the halfshaft from rotating.
Torque
: 37 lb.ft (50 Nm)
- Install the wheel and tire. Refer to: Wheel and Tire .