LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Focus Titanium, 4D Hatchback >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center And Warning Chimes (Except Electric) (2 Of2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test At : The Headlamps On Warning Chime Is Inoperative >> Pinpoint Test At : The Headlamps On Warning Chime Is Inoperative

Pinpoint Test At : The Headlamps On Warning Chime Is Inoperative

  1. AT1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  AT2
    No  GO to Pinpoint Test A 

  2. AT2 CHECK THE INTERIOR LAMPS OPERATION

    • Open and close the driver door.

    • Observe the interior lamps.

    Do the interior lamps operate correctly from the driver door? 

    Yes  GO to  AT3
    No  REFER to: INTERIOR LIGHTING

  3. AT3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: IPC  .
    No  GO to  AT4

  4. AT4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM) .
    No  Refer to BCM GUIDED ROUTINE TESTING
scientia non olet · About LEMON Manuals