Fuel Pump Driver Module (FPDM): Installation
WARNING: This page is about a different variant/trim than selected.
-
NOTE:
Make sure that the mating surface is clean and free of foreign material.
Clean the FPDM mounting surface.
 Courtesy of FORD MOTOR COMPANY
|
- Peel off the protective backing from the new FPDM.
 Courtesy of FORD MOTOR COMPANY
|
- Locate the FPDM over the 2 studs (for location purposes only) and press down firmly.
 Courtesy of FORD MOTOR COMPANY
|
- To install, reverse the removal procedure.