Removal And Installation: Thermostat: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT ELECTRIC) . Failure to follow this instruction may result in serious personal injury.
Refer to: Engine Cooling System Health and Safety Precautions .
- Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
-
NOTE: Be prepared to capture escaping fluid.
Release the clamps and disconnect the coolant hoses from the thermostat housing. Use the General Equipment: Hose Clamp Remover/Installer
- Remove the bolts and the thermostat housing.
Torque
: 89 lb.in (10 Nm)