General Information
WARNING: This page is about a different variant/trim than selected.
NOTE:
Serviceability of the power transfer unit is limited to seals and output flange. If any of the geared components, bearings, case cover or internal shafts fail, a new power transfer unit must be installed.
The power transfer unit is a gearbox that attaches to the transmission. The RH intermediate shaft passes through the power transfer unit and engages the differential side gear as in normal FWD applications. The power transfer unit directs torque to the rear axle through the rear driveshaft.
The power transfer unit is sealed from the transmission and has its own oil sump.
The following components of the power transfer unit are serviceable:
- Power Transfer Unit Rear Seal
- Power Transfer Unit Input shaft seal LH
- Power Transfer Unit Input shaft seal RH
- Power Transfer Unit Intermediate shaft seal
- Output flange