Pinpoint Test K : DTCS U2008:16, U2008:17 Or U2008:64: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to OEM WIRING DIAGRAMS (EXCEPT ELECTRIC) for schematic and connector information.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2008:16 | Sensor Cluster: Circuit Voltage Below Threshold | This CMDTC sets when the AWD control module senses lower than expected voltage on the rear drive unit (RDU) hydraulic pump motor hall effect sensor circuit. |
| U2008:17 | Sensor Cluster: Circuit Voltage Above Threshold | This CMDTC sets when the AWD control module senses greater than expected voltage on the rear drive unit (RDU) hydraulic pump motor hall effect sensor circuit. |
| U2008:64 | Sensor Cluster: Signal Plausibility Failure | This CMDTC sets when the AWD control module detects a short to ground from the RDU hydraulic pump motor hall effect sensor input circuit. |
Possible Sources
- Wiring, terminals or connectors
- AWD control module
- Rear drive unit (RDU)
- Hydraulic pump motor hall effect sensor