Pinpoint Test J : DTCS P0C01:19, P0C05:13, P0C06:11, P0C07:12: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to OEM WIRING DIAGRAMS (EXCEPT ELECTRIC) for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Four-Wheel Drive Systems - System Operation and Component Description .
AWD: DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0C01:19 | Drive Motor "A" Current High: Circuit Current Above Threshold | This DTC sets when the pump motor is experiencing an excessive current draw and is in danger of overheating. When set, the AWD hydraulic pump motor speed is decreased to allow the motor to cool down. |
| P0C05:13 | Drive Motor "A" Phase U-V-W Circuit/Open: Circuit Open | This DTC sets in continuous memory and on-demand if the AWD hydraulic pump motor "A" phase U-V-W circuit is open. |
| P0C06:11 | Drive Motor "A" Phase U-V-W Circuit Low: Circuit Short To Ground | This DTC sets in continuous memory and on-demand if the AWD hydraulic pump motor "A" phase U-V-W circuit is short to ground. |
| P0C07:12 | Drive Motor "A" Phase U-V-W Circuit High: Circuit Short To Battery | This DTC sets in continuous memory and on-demand if the AWD hydraulic pump motor "A" phase U-V-W circuit is short to battery. |
Possible Sources
- Wiring, terminals or connectors
- Rear drive unit (RDU) assembly
- Rear drive unit (RDU) jumper harness
- AWD module