Pinpoint Test H : DTC (Diagnostic Trouble Code) P0563:17: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to OEM WIRING DIAGRAMS (EXCEPT ELECTRIC) for schematic and connector information.
Normal Operation and Fault Conditions
The AWD module requires an operating voltage that is between 9 and 16 volts. The AWD module receives this voltage from the BCM and has a single ground circuit. Excessive resistance or an open in one or more of these circuits, a discharged battery or a inoperative charging system results in the AWD module setting a DTC.
An overcharging condition in the charging system results in the AWD module setting a DTC. This DTC may also set in the AWD module due to battery charging or vehicle jump starting events.
AWD: DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0563:17 | System Voltage High: Circuit Voltage Above Threshold | This DTC sets in continuous memory if the voltage supplied to the AWD module is above 16 volts for more than 3 seconds. |
Possible Sources
- Charging system concern
- AWD module