Roll Restrictor RH: Installation

WARNING: This page is about a different variant/trim than selected.

Install the roll restrictor.
1. Install the roll restrictor and the studbolt.
  Torque
  
  : 59 lb.ft (80 Nm)
2. Install the studbolt, the bolt and tighten.
  Torque
  
  : 59 lb.ft (80 Nm)
Courtesy of FORD MOTOR COMPANY
1. Install the inspection cover. Install the catalytic converter support bracket and the nuts.
  Torque
  
  : 18 lb.ft (25 Nm)
Courtesy of FORD MOTOR COMPANY
NOTE: Bracket not shown.

Install the bolts.

Torque

: 92 lb.ft (125 Nm)

Courtesy of FORD MOTOR COMPANY
1. Install the underbody shield.
2. Install the air deflector.

Courtesy of FORD MOTOR COMPANY