Input Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.

1. NOTE: Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.
  
  Wrap the input shaft splines with tape to prevent damage to the input shaft seal. Use the General Equipment: Adhesive Tape
2. NOTE: Make sure that a new component is installed.
  
  Slide the input shaft seal past the splines.
3. Using the special tool, install the input shaft seal. Use Special Service Tool: 308-847 Installer, Input shaft Seal.
4. Remove and discard the tape.
Courtesy of FORD MOTOR COMPANY
Install the clutch slave cylinder.
Torque

: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Install the transmission. Refer to: Transmission .