Camshaft Position (CMP) Sensor RH: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT ELECTRIC) . Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .
1. Remove the bolt.
  Torque
  
  : 89 lb.in (10 Nm)
2. Loosen the air cleaner outlet pipe clamps and remove the air cleaner outlet pipe.
  Torque
  
  : 44 lb.in (5 Nm)
Courtesy of FORD MOTOR COMPANY
- Disconnect the CMP sensor electrical connector.
- Remove the retainer and the CMP sensor.
  Torque
  
  : 62 lb.in (7 Nm)

Courtesy of FORD MOTOR COMPANY