Ignition Coil-On-Plug: Installation
WARNING: This page is about a different variant/trim than selected.
-
- Install the ignition coil-on-plugs, then install and tighten the ignition coil-on-plug retaining bolts.
Torque
: 71 lb.in (8 Nm)
- Push the ignition coil-on-plug electrical connector onto the ignition coil-on-plug until locked. A clicking sound will be heard when fully seated. Slide the locking tab toward the ignition coil-on-plug until a second clicking sound is heard. Close the slide cover.
- Attach the wiring harness retainers to the ignition coil-on-plug studbolts.
- Install the ignition coil-on-plugs, then install and tighten the ignition coil-on-plug retaining bolts.
-
- Install the air cleaner outlet pipe, then install and tighten the air cleaner outlet pipe retainer.
Torque
: 89 lb.in (10 Nm)
- Connect the quick release coupling and attach the hose retainers. Refer to: Quick Release Coupling .
- Tighten the air cleaner outlet pipe clamps.
Torque
: 44 lb.in (5 Nm)
- Install the air cleaner outlet pipe, then install and tighten the air cleaner outlet pipe retainer.
- Install the engine appearance cover.