LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Focus SEL, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine - 2.0L ECOBOOST (184KW/250PS) - Mi4) >> Removal And Installation >> Valve Stem Seals >> Removal

Valve Stem Seals: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Remove the valve springs. Refer to: Valve Springs  .
  3. Using the special tools, remove and discard the valve stem seals. Use Special Service Tool: 303-468 (T94P-6510-AH) Remover, Valve Stem Oil Seal., 307-005 (T59L-100-B) Slide Hammer.
GFD266156Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals