Valve Springs: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Using some multi-purpose grease and a small screwdriver will aid in the installation of the valve collet. Check the seating of the valve collet.
1. Install the valve spring, the valve spring retainer and the valve collet.
2. Disconnect the compressed air supply.
3. Repeat the appropriate installation steps for all of the other cylinders. Use Special Service Tool: 303-300 (T87C-6565-A) Set, Valve Spring Compressor., 303-350 (T89P-6565-A) Compressor, Valve Spring., 303-472 (T94P-6565-AH) Adapter, Valve Spring Compressor., 303-1249 Valve Spring Compressor.
  Material
  
  : Motorcraft® Multi-Purpose Grease Spray / XL-5-A (ESB-M1C93-B)
Courtesy of FORD MOTOR COMPANY
Install the following items:
1. Refer to: SPARK PLUGS .
2. Refer to: Valve Tappets .