Pinpoint Test C : P0615: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - Overview .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0615 | Starter Relay Circuit | This DTC is set when the PCM detects a fault in the starter relay control circuit(s). |
Possible Sources
- Wiring, terminals or connectors
- PCM
Visual Inspection and Diagnostic Pre-checks
- Inspect BJB fuse 13 (30A).