Pinpoint Test K : U0114, U0414
WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- K1 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a diagnostic scan tool, carry out the Network Test.
Does the TCCM pass the Network Test?
Yes GO to K2. No DIAGNOSE the TCCM does not communicate with the diagnostic scan tool, REFER to Module Communications Network . - K2 CHECK THE ABS CMDTCs
- Using a diagnostic scan tool, carry out the ABS module self-test.
- Using a diagnostic scan tool, clear the ABS module DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Using a diagnostic scan tool, carry out the ABS module self-test.
- Retrieve and record the ABS module DTCs.
Does DTC U0114 or U0414 return?
Yes GO to K3. No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. - K3 REVIEW THE RECORDED DTCs FROM THE ABS MODULE SELF-TEST
- Review the recorded DTCs from the ABS module self-test.
Is DTC B1676 present?
Yes GO to Pinpoint Test A . No GO to K4. - K4 RETRIEVE THE DTCs FROM THE TCCM SELF-TEST
- Using a diagnostic scan tool, carry out the TCCM self-test.
Is DTC P0562:00 or P0563:00 present?
Yes DIAGNOSE the TCCM DTCs. REFER to Four Wheel Drive (4WD) Systems . No GO to K5. - K5 CHECK FOR DTC U0114, U0114:XX, U0414 OR U0414:XX SET IN OTHER MODULES
- Using a diagnostic scan tool, carry out the self-test for all modules.
- Retrieve the CMDTCs from all modules.
Is DTC U0114, U0114:XX, U0414 or U0414:XX set in 1 or more modules in addition to the ABS module?
Yes CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, INSTALL a new TCCM. REFER to Four Wheel Drive (4WD) Systems . No CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) Module .