Differential Carrier - Vehicles With: Electronic Limited-Slip Differential: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the HCU from the rear axle assembly. Refer to: Hydraulic Control Unit (HCU) .
- Using the Transmission Holding Fixture, mount the differential housing to a work bench. Use Special Service Tool: 307-003 (T57L-500-B) Holding Fixture, Transmission.
-
NOTE: The differential bearing caps and differential bearing cap bolts need to be installed in the same location as removed.
- Mark the differential bearing caps.
- Remove the differential bearing cap bolts.
- Remove the differential bearing caps.
- Remove the differential carrier, hydraulic actuator, differential carrier bearing cups and the differential shims.
- Remove the hydraulic actuator assembly from the electronic limited-slip differential carrier. Refer to: Hydraulic Actuator .